Hi all,
I need to weld in some new quarter panels, but my original ones are too rotted for me to get a good measurement for placement of the new ones.
Can any of you who have original rear quarters give me a few dimensions like the attached photo? For the top measuring point, start at the...
Hi all,
I did quite a bit of searching and was a little surprised not to find this somewhere already. Hope one of you can help.
I need to attach new rear quarter panels. The bottoms of mine were missing so I done have a reference point on where to weld them to the side rail. Looking for these...
Hi all. Getting started with my rust bucket and I am looking for the distance from the bed to the top of the wheel wells. See example photo. 1977 FJ40. Thanks in advance!
Hi all,
The floor boards and bottom of my A-pillars are all rusted out. Repairable, I think, but I need a few reference measurements to do it right.
Here is what would be great if someone could check on their rig's A-pillar:
Distance from bottom of the door stop slot to the center of the...
Looking for the support channels that go under the front floorpans and bolt into the frame body mount brackets.
I need both the one that runs from the rocker over to the trans hump and the one that fits up where floorpan meets firewall. Need both pass and driver sides. Putting them on '77 if...
Hi,
So I have a '77 with a frame that is shot and I got hold of a nice replacement that looks solid. It is a rolling chassis -- frame, springs, both axles and wheels. I was told it was from a 74.
I didn't pay too much attention to the axles as what I really needed was the rust-free frame and...
Looking for the side panels for the hard top on a '77 FJ-40. Mine are rusted out on the bottom. Would also consider the whole top but it would need to be close enough to North Carolina for me to come get it. Might consider shipment of the sides if not too expensive. Color does not matter...