The 2nd start button is also nice when driving on the trail in low range when 1st gear is not necessary (between obstacles). It eliminates the shift from 1st to 2nd which is a pretty hard shift.
I have a Viper 751 in my Honda Odessey and it works well. Very good range although not as far as they claim in my real world experience. I have a Hornet system in my TLC. Both are about 1.5 years old, made by Directed and were top of the line when I bought them. I like the Hornet better. It was...
I don't know what my sources where exactly but I read quite a bit before installing mine and I remember being told to use the template for the large hole only. So after marking the holes with the template I inserted pegs into the holes on the snorkel, coated the pegs with ink or paint so I could...
7.5 x 17 Sequoia wheels with 315/70 R17's. I have back spacers front and rear so the center caps will fit on the front wheels. I think the spacers are 1.5". I like that they are different than stock but still Toyota and the color goes well with the sage green. :cool:
I do wish they were 9"...
Would a crack be visible to the naked eye or probably not? If not how could I tell? There is no exhaust smell in the cab though.
There was some rust on the surface the O2 sensors are mounted to. I cleaned them as best I could and I was confident they would mount clean but how would I know if...
I had a signature on here but it disappeared. Sorry about that. here is the info:
1997, 4.5L, supercharged, dual batts using Slee's setup, Toyota O2 sensors
Let me know if anything else is needed. Thanks.
The batteries are two years old or less and are red top Optimas. The charging system is basically Slee's dual batt setup without the disconnect switch in the cab. It has been working fine since it was installed two years ago so I think it should be OK. I did leave the key in the ignition (in...
OK, this is worrying me a little. When I turn the ignition to "on" my engine light blinks 1-2 times a second. When I start the engine the light goes out. It starts and runs fine. It had sat unused for about 6 weeks and I had to jump start it the first time. Any thoughts?
I have been sorting...
Are there any updates to the Palmer software or was it decided that the sensors/codes it couldn't read were not necessary? So far I am leaning towards the Autoenginuity PC based software but I would like to hear some more recent discussion. Has anyone found any new products that are worth a look?
Well I just advanced my timing about 4 deg. It was at about 6 BTDC, now it is at 10. I followed the directions in the link from an earlier post and it all went smoothly except I wasn't able to short out the connections in the ECU service plug. My engine warning light did not blink with the...
I finally figured it out after putsing around long enough :idea: . I was making it way too complicated at first. I just had to start over and keep it simple. Thanks for the help. :cheers:
No. I just want to use a Toyota switch to turn the compressor on and the rotary switch to control the lockers. I have a light switch that I think will work to control the compressor and I know the pin out on it but I can't seem to figure out how to get ot hooked up correctly to turn the...
I know there is a write up on this somewhere, I just can't find it. I am trying to use a Toyota switch to power my ARB compressor and the factory rotary diff lock switch to control the lockers. I ran the ARB wire harness into the cab now I just need to know which wires to connect to the...
I think the 95-97 are the same and maybe other years match too. It has to be tan and in good shape on the outside but it doesn't have to work. Thank you.