Recent content by Yatdolfin

After starting the install, I realized I may have gotten ahead of myself. I will do little things to clean it up and just wait on the body.

I checked and the hole is right next to the bell housing on the transmission. Hopefully it will fall into the cover and will clear everything. Nice catch, thanks for the heads up.

I may or may not have made a mistake. I installed the O2 sensor in my tail pipe behind the collector on my headers. I did not read the instructions well enough and I drilled the hole directly on top of the pipe. I noticed in the directions that it was to be drilled on the side at a slight angle...

I'm rollin on the floor at this sh**t

I was reading his thread yesterday and probably some more today!

Thanks for the grounding tip...might be kinda important!

I'm putting in the O2 sensor today and start running fuel lines. I have a trigger switch that I will use to start it when I'm ready. Of course all this will have to wait until Morris 4x4 sends my dizzy.

I have a 78 40 and doing the frame off restoration. I have installed the rebuilt motor and transmission and I am upgrading to the Holley Sniper. I have the sniper mounted to the intake and wanting to get it setup without the tub being installed. I haven't found a thread yet that is similar to my...

Is there a thread for rebuilding the 2F motor?