Recent content by turbotoyz

260k on 06LX running heavy. Ironman front bumper, dual swingout 4x4 labs rear, slider, rear drawers. Fluid flush every 30k, king spring with 30mm spacer and pressures on the low side of spec. Stock height with 34" tires.

For Sale Vais Tech SL3b-L bluetooth audio. https://vaistech.com/product/sl3b-l/ $210 OBO

My local dealer mentioned the same thing to me as well

I just moved to SW Colorado and I see cruisers all the time.

I can't find a leak above so it's either rear main or upper oil pan near the rear. I added ATP AT205 and the leak is still there. I'm looking to schedule a weekend and drop the transmission and swap the rear main seal.

Initial inspection inside bellhousing looks dry and maybe my upper oil pan gasket is leaking. I'll let you know what i find later this week.

PS has grease staining from the driveshaft but no wet oil. I could look up at the backside of both heads and they look dry. Inside the bell housing looked dry. I will clean up the area, test PCV and report back. Thanks

Oil leak just popped up and overnight. Popped the transmission cover and inside looks dry, from my quick inspection. I am not looking forward to replacing rear main seal. @2001LC would you use AT-205?

Broke a u joint on my rear driveshaft a few weeks back. Bought a new shaft from Toyota and am having intermittent vibration/droning that i have been trouble shooting. I took of my front shaft no change, checked my rear control arms and now discovered this oil leak. I am hoping this is my...

I had similar issue last weekend. Filled up at Montrose with 91 octane (~5800ft elevation) and headed up to Red Mountain pass stopping along the way, but the truck was idling, to take pictures. At the pass shut turn off the engine and walked around. When I went to start the engine it cranked...

My rig is very simular. I weighted mine 06 LX with AHC. Came in at 6600#, Iron man front bumper with winch, 4x4 labs rear dual swingout with ladder and jerry can holder, kiss drawers, tailgate storage, dissent roof rack, metal tech sliders. haven't reindex torsion bars yet and am on King...

Put in new u joints and the joint turns rough when install. I cleaned up the raised metal and reinstalled the joint several times. I am getting vibrations and I have installed and checked driveshaft phase several times.... Looks like a new rear drive shaft might be in order, I am sure Mr T...

Cleaned up and inspected the prop shaft last night. Looks like the u joint that broke was non OE. Placed an order with Cruiser Outfitters for OE ones this morning.

No I don't. Thanks for asking.