Recent content by trd4x4

Got quoted almost $500 for a used 03-06 GX amp. Seem to recall reading that other Lexus models (sc or ls perhaps) use same amp?

Can I ask how to run that radio diagnostic? My girls 2004 seems like it’s having the same issue with no audio?

Thought I’d give a quick update in case anyone was looking into the lseat covers. I got around to installing them a couple of days ago. Not a difficult job and the covers fit pretty well. The big issue is that the clips on the seat bottom cushion where they attach to the side were actually sewn...

Lseat. They arrived. Haven’t had a chance to tackle the install yet but they look to be decent quality. Color match isn’t exact.

I ordered the set. I’ll try my luck with the passenger seat first and if it doesn’t go well I’ll bring to a shop. Thanks

It’s about time I get around to fixing the worn out drivers seat in my ladies GX. Had looked at lseat covers in the past. I think $350 for both front seats. Anybody with experience using these or other recommendations?

Kind of a random idea but I’m looking into repurposing my rear air bags. My boat trailer is about an inch or two too low to clear my driveway apron without stacking 2x4’s under the tires. I’m curious about using the airbags from the GX to raise the trailer while pulling in/out of driveway. Do...

P0031 code came up last night. Cleared and popped again this morning. Upstream drivers side? Have a denso sensor in my rock auto cart. Doesn’t specify driver or passenger side. Just “upstream”. Assuming this is the correct part. Denso 2344138.

This is the missing section

Get tons of help on the 40 and 120 forums. My cousin is missing a small piece of window trim on the passenger front door. 1997. Part number and where to order would be awesome! Thanks.

Put the vin into the Lexus site and it should list all of the options on the truck. It’s been a while but I’m pretty sure that should tell you.

I removed a few under hood and 1 under dash as well. Drivers side footwell fuse panel.

Eibach kit rides great! Didn’t realize how worn the original suspension was. 255/80 falken at3’s. Minor rubbing on inner front fender fixed with a heat gun. Spare in factory location aired down with a ratchet strap. 3/4” clearance to panhard bar. Stoked with the outcome. Tons of thanks to @Tanner H

If that 1/2” extra on the kenda is going to be a problem I’ll stick with 255/80 falken at3’s. I can get 5 mounted and balanced for $1k even. There’s always room for aftermarket wheels, bigger rubber, and body mount chops down the road...