Recent content by tibo123

Anybody knows where is the relay of the lights highlighted on the below picture?

Thanks guys!

Hello, I would like to fit an armor protection underneath the engine, gearbox and transfer case. It seems the offer in France is limited. So, would you recommend a web store (with international shipping) where I could buy such items for my 2005 LC100? Thank you

Thanks. My LC has no mods and I don't intend to carry heavy loads at all time. From what you wrote me, airbags seem to be what I need.

I spent 2 days last week adjusting the pressure within the system (using techstream). I adjusted both sides equally and I also noticed the right side was easier to tighten than the other one.

Thanks for your feedback of the airbags and your advises. Actually, I would need these airbargs to relief the ahc and reduce the risk of failure. Maybe a higher model than yours, as you suggest, would be even more efficient and would allow more flexibility. Do you keep an air compressor on...

I own a 2005 HDJ100 (diesel 4.2). I can see clips on the fuse box but some of them are hard to 'unclip'. So before I try to take appart the upper fuse box and look what is underneath I would like to be sure if I have a chance to find the relay in question.

Hi, The low headlights aren't working on both sides. I suspect the relay (bulbes and fuses are ok) but I am not to know where it is. The toyota diagram shows it is the S relay: I wonder how to access to this one: Do I need to unclip the upper box (where all fuses [and some relays]...

Ok, so the air bags fitting seams to be the best option. Do you have some on your HDJ? Regarding the torsion bars tuning (and in order to give my feedback on it), I have finally tighten it by 1.75 turns which now gives the following pressures: - Front: 6.6 MPa (Toyota specs: 6.4 - 7.4MPa) -...

I thought the 'air bags' were a sort of black humor (AHC fails, I crash the car, I need air bags... :whoops: )

I will try to tighten a bit more the torsion bars and flush the hydraulic system. Since I need to carry heavy load, uHu suggests to replace stock springs by stiffer ones. I have no clue on which ones I could buy. Any suggestion?

Thanks uHu! What kind of reinforced springs would you go for? What do you mean by 'air bags'?

ah ok! But will it increase the rear pressure by 0.2MPa per turn?

I have tighten both torsion bars (1 full bolt turn on both sides). Unfortunately it doesn't change much the pressure values (-0.2 MPa at the front, +0.2MPa at the rear) :( Now the pressures are: - Front: 7.4 MPa (Toyota specs: 6.4 - 7.4MPa) - Rear: 6.6 MPa (Toyota specs: 5.6 - 6.7MPa) The...

Thank you Warrenpfo I have found the piping diagram of the a/c: I think I was looking at the aft one while the fwd one is supposed to leak, I will check again tomorrow.