Recent content by stumpy

Buy a used one from a wrecker. Get the part number off the unit and search the googles. Bits and pieces like this might get on to eBay, too.

I left my bumpstops stock on the rear, haven’t had any issues yet. Went with a 30mm spacer on the rear.

thanks fisher, i'll give that a try. are you just connecting both breathers to the filler neck so both are still connected at the top, or plugging the aux connection at the neck and just connecting the aux hose into the main tank vent? i get my CELs after the truck sits for a few days and runs...

spoke too soon... CELs have returned with a vengeance. checked the filter, still breathing when i am filling the tank. the filter is not caked up with mud. any ideas on what else to chase? i doubt the charcoal canister is clogged again, but i cant think of anything else to mess with. getting...

hive mind- i am having a terrible time finding the thread for the LRA tanks that deals with the venting issue. help a brother out? i have been fighting with this damned tank for 9 months now with the same check engine codes no matter what tricks i do. if i didnt love buying costco gas every 700...

piling on with this issue. i have been chasing my tail on this for about 6 months. turned out my charcoal canister was JAM PACKED with moab silt from a trip in november when i had the original LRA filter installed. I thought it was a plumbing issue to go with the filtration problem, but...

Anyone else get theirs yet? I haven’t heard a peep from GROM yet. I shot them a couple emails to see what’s going on and haven’t heard back. @plars, any tips on the install?

@mattgold

ha! shoulda searched before i dove in. the instructions were a little thin on details. i’m tempted to send some suggestions for adding detail, especially some tips for the LX AHC crowd.

that’s keyed? I guess if the fuel wingding doesn’t constant draw power, it doesn’t matter... 👍🏻

working on installing aux tank and I need to get keyed power. I’m digging into the dash and not seeing anything obvious or gauged enough for 5 amps. any tips? i was hoping something obvious would jump out at me in the fuse box, but no dice thus far. any thoughts? who’s putting in aux fuse...

that's my concern, too. i'd be perfectly happy with the same spring rate with an additional 2" of height. found a custom coil maker on line that i submitted an inquiry to, so maybe they can help figure that out. if the AHC drained drops the rig to the bump stops, the AHC is MUCH more important...

looking to tinker with ride heights on the LX570. do you have coil take offs for a 200? factory stuff only, for now. hit me up!

did you commit to the garbage yet? i am interested in all of what's left for science. shoot me a PM!

i won't be going more than the 20 mm toyota spacer for the TOP of the front coils. that bolt situation was exactly what i was concerned about. i was considering machining a taller spacer that i could put studs into with recessed pockets like a wheel spacer to get more height up front, but i...