Recent content by SQUARE

I’ll check that out as well , appreciate your reply

Do you still remember the part number of the replacement sensor? Did it match the old one you changed? Asking coz I just removed my center console and the one installed right now is 89183-60010. But when I check this P/N at Toyota online, says it is for a 4runner. The one showing for '04 LC...

I see. I’ll check the part number that is installed and will look for a junkyard just so i have a reference. Thanks for the advice thanks, will look for a junkyard and see if i could find one. If not, i’ll have to figure something out.

No lift for mine. Early this year I changed all shock absorbers with OEM parts, re-packed CV axle boots, replaced tie rod end and changed rear brake rotors/pads plus regular oil/filter change. I did the TC and CG to read the DTC codes and got ABS - 44, VSC TRAC codes 33, 34, 36, 43 and 66...

I see. For the yaw rate sensor, may I ask if did you end up getting a new one or used? and how much did it cost? Also for replacing the yaw rate sensor, who did the zero-point calibration? Thanks in advance.

Thanks I will check my other indicator/warning lights. The mechanic said C1234 is the code that he got when he read it and it is pointing to the yaw rate sensor, which is around $430 online. It's quite expensive.

Hello. I have the same issue on my 2004 LC - VSC TRAC and VSC OFF lights are on. No CEL or other lights with it. Once i turned the engine on, both lights remain ON. Are you guys saying that it is possible that the bulbs are burnt out? Just got confused coz both lights are on and if bulbs are...

What's up? I am having the same issue on my 2004 LC - VSC TRAC and VSC OFF lights are on. What is the update with your issue? I tried troubleshooting it myself but I don't have a scanner so I did what the service manual says without using a tester. I got ABS code - 44 and VSC TRAC codes 33...

Troubleshooting this VSC TRAC and VSC OFF lights that I have. Any suggestion?

My '04 land cruiser's VSC TRAC and VSC OFF ights are ON. I did the procedure in the manual to check for DTC on ABS and VSC . My codes are ABS: Code 44, VSC are codes 33, 34, 36, 43 and 66. I don't have a hand-held tester, i just followed the manual in connected Tc and CG, turn ignition ON...