Recent content by snaps

Hi The metal frame that surrounds the glass has rusted in the front, causing it to not wanna open. Everything else is fine. Not sure if anyone would have just that part. Thanks all snaps

I woudnt replace. Id just call that a little "character"

If you need a 61 to represent your product, count me in! Mines a daily, so it will get attention and usage!

No problem. You reminded me that i really need to tear all that out and clean it up and replace the U-joints. And you build is quite inspiring BTW

More pics- better shot of bracket near transfer, the protection plate, the bracket past the plate at the next shaft. Hope this helps

looking into Webasto, thanks , leaving the existing lines alone, sound advice

l yea I like the idea of a separate tank. Drilling into main tank seems a pain- did some of these tanks come with pre-taps for stuff like this? Havent looked- not that lucky! I like your mounting ideas

Hi I know this is an old post, but how did the tank tap go? Would like to do similar. Also where did you mount your second tank in engine bay? Thanks snaps

Hi, did

1988 HJ61 JDM. Sure Thing, Ill get some better pics out tomorrow

m Hey man, lousy pic my apologies, I’m in hotel lot with a dying flashlight. This is a bracket about 20 inches from the last shaft into the transfer. It’s on the LH frame rail, and from there towards the front it’s in a narrow tray hooked to the rail. 88 sixty one JDM. If that’s it, I can get...

Thanks, yea Ill see how good a shape the pipes are after I get em out and clean em. A good thing is a set of clips came with the core i bought, so now if I break one or lose one, which I will....

Thanks cruiser pilot, I think you guys have talked me into sticking to the yota way.

Eurasia, much obliged. I was thinking of having my rad guy solder The pipes for a permanent deal? Gonna brew a coffee and soak in your thread for bit

Hello, getting ready to blow up my dash to dig out the heater core. Its a RHD, hj61. Now I have a ready to go heater from a LHD, 60. Are these parts compatible, or am I in for some more grief( doing this job is grief enough!) Thanks so much!