Recent content by smokeysevin

I grabbed those terminals last week actually. I did drill and tap the holes out so there are now 2 3/8-16 bolts at the top and 1 5/16 closer to the terminal but otherwise they look to be a good piece, they were way easier to get tight than my last set. I like the boots you did. Clean solution...

The absolute best screwdrivers I have used are these from Vessel. https://www.vesseltools.com/handtools/screwdrivers/megadora/motorcycle-repair-kit-detail They are alot more than $24 bucks though. Sean

Not a tree but I have not had a front sway bar on my tundra for probably 5 years now and it drives fine. I do have dr/iconccoilovers, camburg upper control arms, rear deavers, and a rear cantilever setup though which probably helps a bit. As long as you remember its a lifted truck, its fine. Sean

Fuel controller and i/o expander. I am using it to trigger and control some aux functions. TS dash lets you use the rpi gpio to add other inputs to the ecu for things like indicators and switches/buttons. I have an aem anynet can module for some more inputs for things like transmission...

Normally I would agree but for this case, I didn't want extra physical gauges mounted in/on the dash/console for my widebands and extra temp gauges stuck on the dash so I went digital to replace the stock setup and have it all integrated. Sean

I'm doing a TSdash install on my truck now with a 12.3" display, rpi4, and megasquirt 3 for the sensors. The dash layout isn't what I will use but the display fit pretty well in the stock opening. You can do it cheaper than the haltech setup but it is a lot of work. Sean

Dusty from being in the garage while working on the supercharger install but otherwise in great shape. I'd run dielectric grease under the threads/terminals but otherwise they are good even in humid Houston. Sean

I have been using a set of these (5 Post version) on my truck for a couple years now. https://jimsmachineworx.com/collections/battery-terminals/products/sae-top-post-lug-type-1-0 Sean

Are you planning on running cats? What size did you use for the exhaust? I am still in the process but my setup is 2.25" from the headers into a dual 2.25 in - single 3 out spintech muffler. Sean

My bad, I missed it. I would start by swapping one factory part back at a time and see if it does anything. I wonder if the AC compressor clutch is sticking, that could be extra drag on the belt on start up. Sean

Have you cleaned the throttle body? Sean

I have done it both by the book and basically like a half pourover/drip and half press. Usually, I do 1.5 scoops of coffee grounds to start. I fill the press with hot water up to the 3, let it drain all the way, fill it up again, let it drain half way, and top it up, then press it. Its enough...

Honestly, the areopress go has been my favorite. Its damn near self cleaning and you can get a stainless reusable filter for it. The go version packs up super small in its own cup too. I use mine for my every day coffee as well. Sean

Wideband stealth mount. Sean

Moving on, I had some bussed contacts cut from 0.040 copper so I can avoid splices on the power feeds to the internal fuse box. I have one power from each relay coming to the main buss bars, then jumpers to one side of the fuse, then wires out to the devices. I messed up the spacing on...