Definitely air if you started it up after drain and before refill.
You can help a bit by jacking up the front and rear and pulling fluid into the system - this extends the shocks.
My 22 week wait is next week or the week after. I’m fully prepared to be disappointed with having to wait longer and then again when I finally receive the product.
The spacers are needed in the front for sure, the TRD BBS Forged wheels have a taper that doesn't fit over the front hub unfortunately.
I like the look with the spacer so it was my plan all along to use them. Bora 1.25" front and 1" rear.
@2001LC and others...I have my original 06 VGRS rack from my LX sitting here collecting rain, dirt and dust. I installed a new OEM Lexus VGRS rack a few months ago.
If anyone wants it for this experiment it's available.
OK, road tripped a bit up and around Death Valley the past few days and had time to IR temp check the 80mA lights vs the 60mA lights...sometimes the 80mA were 1°F-1.5°F warmer after having the bulbs on for at least 4 hours each day and checking them. A few times I "IR thermometered" and the 80mA...
My rear speakers worked when I installed it, they were not as loud as I would have liked though so I had to bias the balance toward the rear a bit to get them in "the mix".
Everything worked fine in my 06, April 2006 production LX470. I just didn't like it and I no matter how much I tried I...
80mA bulbs in Rear A/C and Rear Defrost vs stock side mirror defrost. no material difference to my eye. Now all interior lights work again. Also 3 bulbs in Hazard switch replaced with the 80mA.
Just noticed my ashtray light doesn’t work though!
@divejoe I believe the blank switch is for a front heated windshield or in other markets a wiper heating section of the windshield (like my wife's 2013 200 series has). The fully heated windshield was available on the Land Cruiser "Cygnus" at least in the Japan market.
Your defroster switch...
I haven’t felt anything irregular. Replaced rack at 270k with new Lexus VGRS rack. 2006 LX. Snap ring appears to be in correct position.
Intermediate shaft #2 has some play in the U Joints.
I have some light pop/knock noise at low speeds when turning. Hoping it’s the #2 shaft as that’s the...
I just went through this. The standoffs for the “brown rectangle” bulb holders are fragile and I had to re-flow the solder on one of them. No real skill required just heat enough to fix the cracked solder joint.
I did this with the 80a Tanin Electronics bulbs. Worked for the hazard too with...