Recent content by Recon1504

Still have the roll bar?

Hey Alberto. Probably don't remember me, I bought the 3B/5 speed out of your 70 series back in 2015/2016. My project stalled out with other house projects and work. Recently, I picked up a 1984 BJ-42 that has a cracked head; however, your old engine combo will be going into this instead of my...

Looking good Alberto...

The reason I was asking for stock 3 speed measurements, I was trying to establish a correlation between installed length versus fully collapsed length. Based on a couple of responses and a thread that I found while searching, I am using a 1" deduct from installed length to fully collapsed...

Changed out the pinion flanges to 60x68.5 bolt pattern and getting late model FJ40 driveshafts cut down to fit. not using any of the 3 speed stuff...

Those measurements are great. They, along with bikersmurf's post confirmed the 1" +/- difference between collapsed length and installed length. Driveshafts heading to the transmission shop this afternoon to get cut down and balanced...

That works for me. I've been measuring from center to center. I have a diagram that I can post tomorrow.

The lift will throw off the measurements, but your measurement will help me determine if the 1" difference is correct in a general sense.

I used the .pdf for the BJ frame that has factory measurements for the engine mount locations. They were located as close to the factory specs as possible. I did find in another thread today where it was stated that the fully collapsed length of the driveshaft should be approx. 1" shorter than...

Need the flange to flange (front) and the e. brake drum to flange measurements for a '71 (or similar setup) with F, 3 speed/T-case. Trying to figure out how much adjustment was factored in for a fully collapsed driveshaft to an in-place driveshaft. I am in the process of upgrading to a 3B/5...

Driveshafts?

Front/rear driveshafts?

Still have the power steering gear box? Condition? Price shipped to 43469?

Still have the power steering gear box? Is this the later style with offset mounting bolt pattern? Condition? Price shipped to 43469?

Still have the power steering gear box? Condition? Price shipped to 43469?