Recent content by PurpleFJ62

  1. PurpleFJ62

    For Sale SE Mich - 2001 4runner rear axle housing and non locking differential

    I just upgraded my rear end to a locking one so I have a clean and straight rear axle housing that fits 3rd gen 4runners, it includes the 3rd member. Given highway cruising rpm's I am almost certain its a 4.10 ratio but I did not actually count the teeth on the gears. Only has 71k miles on it...
  2. 20190410_140245.jpg

    20190410_140245.jpg

  3. 20190410_140205.jpg

    20190410_140205.jpg

  4. 20190410_140219.jpg

    20190410_140219.jpg

  5. 20190410_140152.jpg

    20190410_140152.jpg

  6. PurpleFJ62

    Cummins 5.0L V8 - Thoughts from the diesel swap gurus

    My r2.8 does not even fit that good in an 80 series, i think that the 5.0 cummins v8 is a no go in any land cruiser.
  7. PurpleFJ62

    Another 1992 FJ80 ready for parts!

    Throttle cables is FJ80 came with cruise control, shipped to 48103. Thanks!
  8. PurpleFJ62

    Builds Cummins R2.8 H151 Swap into 1993 FZJ80

    If its possible to make both the cruise control and primary engine throttle work with a witches brew of parts that it should also be possible to keep the OEM 80 series hand throttle since it interfaces with the throttle pedal. Does anyone have an FJ80 throttle cables they would be willing to...
  9. PurpleFJ62

    Builds Cummins R2.8 H151 Swap into 1993 FZJ80

    Finally added the stiffener bracket. Should help keep that long beam like member from vibrating too much. I really wish I could have put the ECM in the cab, maybe under a seat or inside the center consoul, but that connector is so big I don't think I would fit between all the HVAC crap.
  10. 20190331_102121.jpg

    20190331_102121.jpg

  11. 20190331_102111.jpg

    20190331_102111.jpg

  12. 20190331_100049.jpg

    20190331_100049.jpg

  13. PurpleFJ62

    Builds Cummins R2.8 H151 Swap into 1993 FZJ80

    Thanks for sharing that picture. I found a FJ80 Cruise Control Actuator on ebay, I have not verified that it works yet. It seems that one of the pulleys has no return spring, is your like that? I guess the throttle body return spring is responsable for pushing the cable back and taking any slack...
  14. PurpleFJ62

    Builds Cummins R2.8 H151 Swap into 1993 FZJ80

    Its been awhile since my last update. Things have been super busy and I have not been free to work on the LC much as of late. I extended the R2.8 engine harness 18 inches to reach the location where I mounted the R2.8 ECM. That was a real fun job I must say. I hope I did not mix up any of the...
Top Bottom