I agree, if you are doing that work get an ls in there or a Toyota motor of choice. You might be able to find a complete set up with 4 speed or better and get a splitcase too which would save alot of work.
Yeah, where the one side threads into the shackle it sheared. If you look after that bolt is drilled for grease channel and threaded there isnt much left IMO. Add hard rock crawling with twist loads from springs.
did your friend look at the center pin while you were turning thru the motion ? its visible. FWIW I ran those shackles until the bolts sheared, I'd check those shackle bolts well, specifically the end that threads into the dogbone.
No but there may be some money in all the parts. Little things like thermostat housings, brackets, drivetrain, control rods/cables, if gears/axles good, tcase good, steering then overall might be worth just disassembling completely, dump the...
I agree, the layout and build is well done. Do you guys a battery decline curve for diff batteries or for the one in the 40 ? I ask because my 300 mile range has decreased to 268 in 3 years and I have taken proper care of batt/charging and...
Look at Lensun semi-flexible panels, I used e6000 adhesive to stick em down and I put a piece of 8mm double wall polycarb panel between panel & roof for heat.
A " Rod out " is a term used for hot tanking and cleaning a radiator or block or whatever, it involves sliding a rod down the radiator tubes or thru the water jacket to dislodge/break up/remove debris, etc. Put a bucket under and flush at will
Well, i guess I have to eat my words and partially retract my complaint.
Recently my Dometic fridge kinda died. I say kinda because I got an error message on the screen that couldn't be cleared no matter what I tried. The fridge itself would...
Well thats a good ?. I do not but was interested and have been following these threads. I assume you are aware of the discoveries made by others regarding Topnault tub's issue in fitment. I see on Relik's site the 3/4 at 6,999 seems to include...