Recent content by Norseman12

haha thanks. I got lucky and put in an order for a gasket that looked about right before I saw your messages, and turns out it was the same part number.

Awesome - thank you. I did not see that section!

Does anyone have the part number for the gasket under this water line, or know where to find it? Seems like most people replace the T-stat housing gasket and the bypass o-rings, but mine appears to be leaking from underneath this fitting. I don't see it on any parts diagrams. Thanks, Mark

Link doesn't work - anybody have a current one?

Thanks for the information. I would be wiling to give it a shot if I had garage space, which currently I don't, and a spare daily, which I won't have until the end of December when my 4Runner is supposed to be here or spring motorcycle weather. I have a lot of maintenance and upgrades to do...

Thanks for all the input. I'm going to contact Cruiser Co and Japanese Auto to see if I can get in for a diagnosis. I may have a chance to buy a used A343 and transfer case in allegedly good condition. Would those work if my A442 ends up being damaged?

Where are you located? What kind of cost, time, and parts purchases are you looking at for that job?

I did the full flush and fill through the trans cooler line. The old fluid seemed ok, but I didnt drop the pan, so I don't know how the inside looked. Didn't seem to be fragments on the drain plug. I've never had an auto trans apart - are clutches within the scope of a home mechanic?

I definitely need to rebuild the axles. Unfortunately I don't have a garage and it's already cold and snowing up here, so I don't know when I'll be able to test into them.

Hello, I have a new-to-me 1994 FZJ80 with 260,000 miles. As far as I know, it always had stock tires on it and was not wheeled nor abused. Since I purchased it, I flushed and replaced all the transmission fluid, and fiddled/tightened the kickdown cable. I also towed a 6x10 trailer from...

PM sent PM sent

Is there a way to decode the Yazaki connectors, or does anyone have part numbers? I'm trying to find the correct male and female connectors to make a pigtail from under the seats to horizontal switches near the rear heat fan button. Thanks.

Bummer - I just got to Denver. Anybody else have something for sale?

I bet you're right about these being intended for the 100.

Ah - just noticed it's only left side, and I don't see the right side anywhere.