Recent content by MastiffDad14

I don't sorry. I just got lucky and found the exact same part on ebay.

for what its worth I also ran into the same issue and it ended up being a bad board. Got lucky and found someone selling that entire dashboard piece with the buttons and board for $50 bucks.

I would want to see the rest of the truck and the condition its in. I wouldn't immediately pass.

Those first 2 pictures look awful, the actual frame looks in good shape but its never good when you can see through the unibody.

Ok, took some measurements. DS Front 22 1/4" PS Front 21 1/3" Both Rears 23 1/4" The DS Front had less than 1.4" of droop. I am going to lower it down to around 21 1/3" to match the passenger. With the drivers side unloaded and raise in the air the torsion bar bolt is stuck, can't get any...

Thanks for all the responses, ill check the droop today. Hopefully that is the issue, I am going to assume it is since there is no way I would say this rides well.

It Great question, I should have specified. It’s always been this way. I installed the suspension components about 12 months ago. I’ve been driving the vehicle more and it’s just bothering me.

Good afternoon, I was hoping someone could point me in the right direction on how to cure my suspension woes. Currently using the tough dog shocks can’t recall the style but they were the better ones with rear adjusting front and rear along with TD torsion bars and constant load heavy coils...

Wondering if you got around to installing these and how everything went?

Curious to hear what other members have to say as well, this rack looked like it fit the bill for what I’m looking for too. Low profile, strong and lightweight.

bringing up an old thread but if your going to dynamat also cover the area with 1lb mass loaded vinyl to further cut down on the noise. This will make a larger difference than just the dynamat alone. You should be able to buy 100sq feet for under $200 for the roll. Do the rear cargo area, wheel...

Thanks they are m14 x 1.5 bolts right?

Quick question, on the cross member what size bolts and spacer did you use to attach it to the frame? My kit didn’t come with 4 bolts for the cross brace and I don’t see them under my truck to reuse. Thanks! ,

What pads is everyone using? I am currently using OEM toyota pads.

Hi Fam, I was wondering what brake options are available for our rigs. I have a fully equipped truck. 295/70/18 eload tires,TJM Bull bar front bumper, Slee rear with dual swing out, fridge, drawers, steel skids etc, I could go on but you get the point. The truck is heavy and does stop all...