Couldn’t find a diagram that labeled this bolt...but for some stupid reason I screwed with it and now have no idea what it does.
Anyone know what it’s for and how it needs to be setup?
Just installed my turbo kit on the 60 and Im not really making any boost.
I get a spike at wot to about 3-4 psi and that drops to 0 as soon as I back off that gas at all.
Ive got a leak on my throttle shaft but there is no listing for a seal or gasket there and nothing shown in the diagram...
My H55 in my BJ60 has always shifted fine but it was really loud. I had the seals and bearings in both the T-case and the transmission done by a shop and its gotten much quieter.
Only noise Im hearing now is this whistle/whine in neutral, especially at higher speeds.
In gear is fine, take it...
Ive got a 60 with an OME lift in it and it bugs me how much the U bolts stick out. Looks like I've got about 1 1/8'' of extra thread length that loves to catch on things. I thought I could just buy a 1/2 or 3/4 spacer blocks? This would fix the U bolts hanging down so much and give me a bit more...
1984 BJ60 (3b diesel) with power clutch....
Trying to solve a soft brake pedal issue.
Lets say I'm braking hard coming to a red light...brake pedal goes down about 60- 70% travel, as I get closer to a full stop I lift about 50% off from the pedal and then re apply to come to a full stop, the...
Well that was easy!
Used a small flat head screwdriver to straighten the pin out and a pick to pull it out.
Small mirror was a big help.
It could be totally in my head but on my 10 min test drive the power clutch and power brakes actually felt much better. I think they run off a separate...
Can someone please post up the link for the write up on changing out the diaphragm on an 3b injector pump.
Getting some mixed info on how hard this is...some say its 2 hours and some say its almost impossible with the motor in??? Im daily driving the 60 so I need to be careful with what I start ;)
Ive got a 3B that leaks oil right above the water pump.
Read several threads on this and Im still a little bit unsure on what to do.
It seems like a really common leak...are all you guys doing head gaskets?
The leak is too bad for me to ignore but Im not really eager to do a head gasket...