Recent content by LSUfj

Looks terrific!. Couple questions: 1. Did you make the hard fuel line to the sniper? Or is that a Mosley component? 2. Did Vintage air change the compressor bracket or is that still the OEM alternator bracket I see?

Bought from Rockauto, but decided not to install because it doesn’t have the bosses for the OEM dust shield. Harness connection and mounting points are all correct. Asking $100 plus shipping (sells for $140 plus $73 core)

Is the one to the left of the “32” just a blind hole, not open to the oil passages? Wondering if mine was drilled/tapped by the PO.

I’m trying to sort out these two holes in red. One is the OEM location for the oil sender. Was the other OEM, or added? It had an aftermarket mechanical gauge and the OEM gauge when I got it. Just wondering which is the original sender location and if that other was added or was plugged from the...

I received some hardware recently after an email and a few PMs. It was a bit of a wait, but it all came and included a few extra stickers.

I was just reading about a Toyota ac refresher kit a few days ago. It’s a foam you spray into the drain to clean the coil. You’d have to clear out a plugged drain first anyway, so that’s the first step.

Agreed.

I would bet the valve assembly is allowing fluid to pass. When it pressures up to raise the suspension, these valves should close to keep the pressure/fluid in place. I’ve been eyeing this repair and part to avoid being caught with the part no longer available. I don’t have an issue just yet...

The clamp around the AC line with the rubber isolator is refrigerant pipe clamp 88718-60880. It doesn’t come with any of the hardware.

Are these the flat version or tilted up a bit? How’s the step functionality? Looks great.

I ended up sending the intake off to @cruisermatt for a crack repair. Service was fast and price was fair. I also decided to pick up some 3FE exhaust manifolds. Other general progress: Cleaned head bolt and bolt hole threads, torqued head down Installed rocker assembly Steps backward; While...

Great. @cruiserland . Let me know what turns up.

Excellent. Will PM.

Looking for a good (no cracks) 2f manifold. Reach out if you have one! Thanks!

Some goodies showing up for the eventual sniper addition. I dug an extra intake out of storage, but it’s also cracked. Looking into repair or replacement. Also have a good exhaust manifold. What’s the consensus on headers vs OEM? Plan to keep the OEM exhaust manifold unless there’s a compelling...