Recent content by lnnguyen01

Thanks!

This one in blue? Thanks so much!

Is it this in the red area that's held down by two bolts? Thanks

Sorry if I sound stupid but where is the place to add more grease? Thanks

If so how long do I have? It's my daily driver but only 10 miles/day. I probably can't get to it for another month. Thanks

I know this thread is from 5 years ago but my plastic tip on ABS sensor also fell off. Going to glue tip back on and hope for the best but does anyone else have a better suggestion? Thanks

Hi, does anyone know what the part my finger is pointing to in enclosed pic is? (pic may be upside down) The little plastic cover fell off and I can put it back on but it's very loose. I'm afraid it's going to fall off easily if I don't do anything else and just put everything back together...

Just FYI for those looking for the SST 09509-25011 Rear Axle Bearing Lock Nut Wrench. It's 3-4 weeks backorder through cdan. I got this from a past IH8MUD thread. http://toyota.spx.com (800)933-8335 $49 ships out by this Friday. Also any suggestions as to what to use to clean off all the...

I got it locked on the jack stands with no problems! Now waiting on parts to proceed with axle service. Thanks to all for the help!

Thanks for all the replies! I went out of town after posting but will try Tues/Wed. Stupid question but how will I know the locker engaged? Will I hear or feel the clunk after turning the axle?

Hello all, I was putting in new rear brakes pads and rotors (97 LX450) but then saw a bunch of grease after I removed the rotor. So looks like I need to service the rear axle. Thanks to all the great writeups and pics will give it a go myself. Will contact Cdan for parts along with SST. A...

190K on my LX450. No CEL. Any reason to replace? Thanks

Just FYI update. I replaced the contacts this week. It was difficult removing the two starter mounting bolts as space very tight but replacing the contacts were easy. I laid the starter upright on the ground, did use a vice, wooden block, or press. Just used my thumb to press down. Seems to...

Hi, I need to replace my starter contacts. The instructions in the FAQ from George Starter Motor Contacts says to use a wooden block on the contact plate and press it down with a hand press to 221 lbf. I don't have a hand press! Can I do this without a hand press? Hope this is not a stupid...

I just did this today for my LX450 third row. About a 5 minute job. Just unscrew the plastic cover underneath the seat (3 screws and don't need to mess taking the seat apart), threat the new belt through from the top on each side and attach to the bolt holding the existing seatbelts from each...