Recent content by kansascruiser

I tow with my FJ60 all the time. I tow a full size skid loader(Bobcat) on a dual axle trailer. I tow my 28ft dual axle camper weighing around 7500 lbs. It can be slow going but it doesnt seem to phase my truck. I have stock 2F and h42. on mostly flat ground it cruises 55-60mph, takes a bit to...

fj60 frame Whats the condition of fj60 frame?

Whats the condition of frame?Where are you located?

steering box What condition is steering box?any leaks or free-play where pitman arm attaches?

thanks guys. I'll head back out to the garage this evening and get them flipped around.

I think i installed my front springs the wrong way with the military wrap facing the front of the vehicle. I realized this after I got everything installed on both sides. So my question is should i go back and flip the springs around or just leave it the way it is? The springs measure the same...

Your PM box is full.

I need a charcoal cannister in decent shape and the rear suspension bump stops if you have them. How much are you wanting to get out of the rebuilt 2f? Thanks, Will

I had the exact same problem as you. Mine ran good and started fine, but just as you said when it would sit over night it just didn't want to start. Turned out it was my distributor. The insides of my dizzy were so corroded from moisture that it wasn't getting enough spark to start. Why it...

Could you post some pics?

Thanks for the help, I am going to get a new master cylinder and see if that fixes the braking problem. I have a vac gauge hooked up in the cab and it reads 18 at idle, which I think is pretty good. At times though, the needle won't be rock solid and flickers right around 18. Is this normal...

I think my brake booster is bad. But after checking the price on a new one I want to be absolutely sure that its really the booster and not something else. Brake boosters for these vehicles are not cheap by any means from what I have found. At times the pedal goes all the way to the floor...

I guess I'll just wait and see. It is kind of annoying though:mad: .

Went to get something to eat this evening and the whole way there everything was fine. Got back in after about an hour and cranked the heat up and noticed an unusual vibration. The noise and vibration goes away when the heat is turned off and comes back when turned on. Is this just my blower...

Is the frame still solid? Would you say it runs well enough to drive back to Kansas?