Recent content by Jimmy cruiser

Just a thought, if you put a 1mm washer under the release fork ball with the increase in moment you may have your 5mm.. no, on second thoughts there will be almost no increase, due to no moment increase, alternatively you could have another machined up providing there is enough clearance in the...

Its locally manufactured specifically for the 1PZ. The OD ring gear tooth to tooth measurement is 356 mm. Ring gear axial location starts 9mm from back of crank. How doe this compare to yours? Cheers

The flywheel I have installed is 51.5mm from back of crank to friction surface - this is info from my clutch guy over the phone, he also cautioned against the use of a 1hz flywheel because of the ring gear location and meshing with the SM, apparently its further back on the 1PZ than the 1HZ...

Yes you are correct, unsure of the measurements as it's installed now😞 but going as good as new, I'll make some enquiries this end and get back to you, Cheers

Here's some pics of the clutch and pressure plate before install maybe it helps, to=full]1943504[/ATTACH]cheers Dave

Hi there, from fork contact surface to the clutch side of the bearing is 46.2mm. P/N on box is 58TKB35003AR ENSS 812 no sure if it's true to label tho, here's some photos

Hi there, have recently replaced mine, it's the one on the right, my truck is a 1991 jdm PZJ70, with a solid flywheel replacement, it's the second I've owned and done, great refurb thread, let me know if you would like me to take measurements as I've said spare on hand in the workshop,🙂 Thank

Hi there, have recently replaced mine, it's the one on the right, My truck is 1991 jdm PZJ70, with a solid flywheel replacement, I,ve had 2 PZJ70s and done them both. Ive a spare in the workshop if you like dimensions. Great refurbishment thread ! Thanks

Hi, to date a terrain tamer 2" lift, along with the new rubber mentioned above. Been pre occupied with finishing the rebuild of my 91' PZJ70, I would imagine the same running gear as yours, R151F gearbox, 1pz and with factory lockers front and rear, you've inspired me to post a build thread...

I like your thread, I've recently got my hands on a HZJ77 400,000 kms sweet as a nut, factory difflocks, ARB bar, spotlights, arb roofrack, drives sweet but struggles a little with the roof rack at open road speeds. I've just put on a TT 2 inch lift and am running 255/85 R16s which are primo and...