Hi I have a hj60 2h 24volt 1989 landcruiser. I have take everything apart and now put it tougheter. Now it wont start. I have electricity to starter and relays work. Inside cab I have electricity to hazard light and high beam. Nothing more. If I hot wire The starter The engine cranks but with...
hi I have a hj60 2h 24volt from 89. it does not want to start. I have taken the whole car apart and now I have assembled everything and have installed the electrical system. I have measured and have 24 volts for the starter motor that works. I have electricity for the generator. I have...
Thank you very much every one.
i have something in left fender that i dont know What it is will have a look When i have time and take photo.
I will have a look in the back of the car too
I found the tach and i think i moved it a little and then i clean it with brake cleaner and after that it worked
Changed my old generator for a new same model but the banjo bolt did not fit in the new generator. I discovered my oil pressure droped so i go out and check. Dripping from vacuumpump...
Hi i was fixing some Cables to the starter solenoid and i had to open my electric harness after that my rpm gauge did not work. Were should i start looking and How Can i test if its the gauge itself
I trying to install a 24v to 12 v converter and i have read about People use cigarett lighter...
Hello im trying to install a 24 to 12 volt converter using my old radio cables and im trying to indentify witch color cable goes where and have so far indentify that the blue and yellow cabel is + and the grey is ignition + should these both go to my converters +? And is the brown with blue spot...