Recent content by jbucchi

On my third set of ripped cv boots If your torsion bars are doing good, I’d leave everything alone till you have to turn a wrench :)

I put the Fox 2.0 105 shocks in the rear cause the old man emu we’re to small. Although having a really nice ride, an smooth feel.. needed a bigger shock to level the truck out... drove to Compton California an went to the headquarters of one of the bigger 4x4 stores an asked about getting a set...

Loop just means the shock slides on a bar an ranchets on a stationery tighten.... pin means it go’s threw stationary position to lock down with a nut.. 2000 100series for me... 100 series shocks were too small an we’re really only going 1.5 in the front an I needed more.. so I went with...

I had old man emu rear shocks, they were nice, not to bad.. used those till the 105 series rear’s came in.. both front an back are loop to pin.... I put the 100 series fox 2.0 rears shock up front.. to give it the extra inch or so.. almost put 37’s with 2 inch body lift.. but stayed at 35’s the...

U can crank your torsion bars an add new rear springs.. just b carefull , my cv joints were old an it speed up the wear.. I cleaned them up an ordered a new reboot kit, good as new... I tried aftermarket cv joints an they were bad.. so stay stock :)

Your right total chaos my bad

Ball joint Nitro UCA vrs uni ball total chaos .. uni ball sounds like the way.. went with Old man Emu front torsion bars, they seem to look the same as the one’s I took off... went with the OME heavy spring’s differential drop looks the same too as stock Toyo 35 MT’s...

2000 100 series 270k So far the Fox shocks an Nitro upper control arm’s are working well together... using the 105 series front fox 2.0 was a gamble but workout nicely.. the 35 inch Toyo MTs have great traction an low hum on the interstate.. mud/dirt an trail, great...

Howdy, I went Nitro upper control arms, an Fox my buddy uses Controlled chaos, with King shocks.. if I was going to do it again, I’d go Controlled chaos an King

Hello everyone My name’s J... been working on my truck as much as I can. Went Hutchinson beadlocks 17x8.5 , toyo 35x12.50 17 mt... pretty happy but feeling remorse for not going 37x13.50 17’s. Guy’s at th shop we’re working at telling me I needed a lot more work don before an I agreed yet; two...