Recent content by Haspin FJ

Glad this has helped. Somehow just got notification of the most recent reply and missed those before so apologies. Mine is still running fine currently. I did clean out amd "fluid film" the interior of the lift gate and exposed metal parts of the new regulator when I installed it in the write...

Got ya. I'm not particular to Renogy, just what I had available from another project so figured I'd make use of it, and theoretically better then some of the No Name total garbage low end "Amazon" stuff out there, although I'm sure some of them are probably comparable. Thanks for all the input.

It's a Cerwin Vega sub with a built in amp, nothing crazy, probably 100w, and I barely turn thing up much these days as well as my current stero being volume limited with some issue it has. Regardless I'd want to keep it right. In all honesty installing it is more to have the rig solar ready and...

Good point. May take some trial and error I guess for that.

Thanks. That was my thinking as well but wanted to get some external input, lol. Yes, I'm just talking about the thick +/- wires coming from the battery to the amplifier. I'll probably install a small fuse block just before the amp to tie both into and fuse the two sources independently based...

Wondering if the power from a solar panel charge controller can be tied in directly to existing heavy gauge wiring going to my powered subwoofer in the back passenger quarter panel instead of having to run more wires all the way back to the battery? Seems like it would be basically doing the...

My local dealer (Cincinnati area) offers close to the same online pricing as some of the big names (McGeorge, toyotapartsdeal, etc) however they are running an extra 15% off of their normal pricing for the next 18 hours. Figured I'd let folks know. https://autoparts.kingstoyota.com/

Redneck hack: Peel some of that booger like glue that comes off and stays soft that you get sealing some folded junk mail. Ball it up and use a business card or "rewards" card to insert it in the crack between the vent and housing. It will hold it in place however not perfect as it has some...

Just hit ATR at Windrock this weekend after popping it back in so hope it's still there 🤣

Been away for a few days. Thanks all.

I found this part lying under my parked 97 fjz80. Reminds me of the transmission inspection cover as far as the construction goes. Anyone know where this came from?? TIA.

I had an old 91 Toy pickup that started doing a similar thing as it got older. I threw multiple starters on it as had a lifetime warranty from a common parts store and they kept replacing it. It helped almost everytime when they were brand new but finally got worse to where I knew it was not the...

They are held on by 3 10mm headed screws and take less then a minute each to remove. I run mine to the wheeling location and remove them before I hit the trail if it's going to be fairly extreme just in case.

I've had the issue with the driveline vibration on decel or when coasting at highway speeds. Put a low mileage TC in just because mines felt a bit rough sine I got it and figured it wouldn't hurt to have a spare and eliminate one component. It didn't work but is nicer feeling. The issue was...

Subscribed. Just started looking for a solution as well. I had noticed a LED lighted frame at Autozone made by Pilot that has white LED light around the entire perimeter that cam be wired to switch to red for a brake light. Only seems to come in chrome though...