Recent content by greg

thanks for the help,i went to toyota dealer

thanks, I will call him,has anybody had luck finding intake gasket set from local parts stores,1974,1F?

i have 74 fj40,1F, Napa shows only intake/exhaust,heat riser gasket set available is,the newer style from 75-?,heat riser gasket has 5 holes, I need the fel pro set where the heat riser gasket has only 3 holes, and smaller as well. called advance,auto zone,same answer also, called tech rep at...

bigger plug a bigger plug is what i am wanting to try ,i think i can find the right plug, having hard time finding the right size helicoil, with a bigger plug, with bigger threads , i might not need the helicoil? any thoughts on this...

Man have i screwed up this time!!! couple years ago i am cruisin down the road in my 95 tacoma 4by v6, i hear this god awful sound, limped home spark plug worked loose and blew up the coil pack big time!! did a heli coil ran fine for 10k, BAAAM!! blew another one , installed another helicoil...

so far so good replaced coil and resistor this morning so far so good, thanks for input.

i have less than 200 miles on a jim.c rebuild,new toyota fuel pump,filter,d.cap,button,points,plugs.vacumn holds around 17 at idle,fuel idle switch on carb has power to it when problem occurs, the problem is the cruiser will just die on me it does this cold,warm, choke open,choke closed,when...

sun visor hardware want to buy sunvisor hardware 58-78,blades not needed.

been asking everybody for the borrowed 33 experiment no luck yet ,i dont think im going to notice a difference from 31s to 33s its worth a try for sure . you have to drive on alot of pavement to get to the dirt around here, im not really lookin for more top end speed just a little more driving...

1. will a 60 rear axle swap into 74-40,1f 3spdtrans and transfer for a higher top end for street ,if not what options do i have? 2.will i notice the difference if i go from 31 to 33s top end ? thanks in advance the knowledge on this site is top shelf.

best place to buy a 2.5 bds lift,also with just a 2.5 lift any other mod need to be done? thanks in advance..

spare tire carrier lock/catch wanted 58-74 right hand side

thanks for the input hamma,saw that item myself might end up being a good deal,the more tech links i read the more confused i get,my 40 is driven 75%street,25% trail im lookin for the easiest way to make top end speeds a little more comfortable,any advice?

clutch is on its last leg ,perfect time to do a 3spd to 4spd tranny swap,should i keep my 3spd transfer and mate to 4spd tranny or install 4spd trans/tfer combo any advantage between the two,anybody got a 4spd for sale , 4spd bellh,clutch fork,drive shafts basically everything needed to do the...

does the fuel cuttoff switch on back of carb single wire go to the ign switch 74f .also does the nut that mounts the fuel supply line to carb regulate fuel in any way ,kinda pointed with a hole in middle?