Recent content by Dunkane

no source for a correct panel with upper side channel ? :rolleyes:

hello where to find a right rear side panel with upper chanel for a 1964 fj40 ? (same until 1969) complete side panel even without the round gas filler. best regards

can you give me somes measures ? of the rear on your ? thank you

ok i found why, 5 mm difference because the guy who made took the model on a bj42 and seems it was yet repaired so maybe here is the mistake for me too check..

i have exactly the same issue with a new rear sill and new quarter panel on my 64 fj40....a gap of 5 mm , so maybe there is a shape difference between the new quarter panel coming from my donor, bj40 1980, and the 64 fj40.... i measured on a RHD and sill is ok, 60 mm from floor to bottom...

hello, Where to have complete new 1964 fj40 ignition switch+ doors matching ? (same key for doors and start) best regards

try asking www.lrc.eu about thoses parts. luc and robbie are nice guys !

hello , are somes of you can give me measure from floor to end of rear sill , to compare with a 1980 fj40 or bj42... seems there are somes differences i need measures in yellow thank you

their tickness is 1.2 mm...18 gauge...mesured on their part by a friend who import somes of their parts...

Success....

Done yet .

Hello How to remove this After removed screws ? (I am changing side panel )

thank you, blue one on my post was one of Proffitt cruiser, have been modified :), he just said me this by mail :) thank you for your help

ok this guy sell juncheng steel like this one