Recent content by dronning

Just an FYI An '97 LX450 with lockers and 35K miles just sold for $17K. It looked like it was fresh off the showroom in '97.

Many of todays GM & other engines that have an injector per cylinder use this method to get better mileage. "Active Fuel Management™ deactivates half the engine cylinders when they are not needed and seamlessly reactivates them when you need the extra power." The key is you need to be able...

Price and pics? I had 4 Blazers over the years - all were pre 1979 all locked up (ARB) and lifted - loved them. Just a heads up without a price this may be pulled by the moderator based on item 4 of the guidelines. 4> PRICES are required.

FYI for a comp A locked/loaded LX 450 with less than 40K on it just sold for $16,500 I think it was on eBay or Autotrader Good luck someone will want a low mile truck. Dave

LC prices are dropping (gas related?) so if you are buying you'll have more money for accessories. Dave

If the roads have heavy wear from truck traffic the wider tire will try and climb out of the grooves in the road, I have a Corvette that is terrible on grooved roads and I don't notice it at all with my other vehicles. Dave

Thanks! Dave

I did a search but didn't find an answer and this may be stoooopid but. Ok I'm just getting started and have found a couple of rigs I dealing on and need to know. Are all factory LC locker options the same or are there different versions? like rear only, center only... And most importantly...

Thanks for the quick reply. Unfortunately I think he has been driving it this way for a while just adding af as he went. Body looks good but it's had a cheap repaint/color change and they didn't do the door jams. No lockers - I just found this out. The interior looks good leather, sunroof...

New to Cruisers I'm looking at an 1996 80 that is using antifreeze - it's going through the motor. I haven't seen it yet but what should I expect cracked head, head gasket or worse a block. I will be looking for af in the oil and for oil in the af. How hard is a head replacement on this...