Recent content by draperyl

Looking good D! Cant wait to go explore next week with our FJ's!

Does anyone still produce these? I have seen them and searched everywhere but can't find them.

Nice sliders. If your ever heading down to Vegas let me know I'd love to put them in my beast.

Wish they would my fj60 been looking for some.

Just sent a PM if you still have them.

Love that color!

Funny you say that I saw it on a rig yesterday.

This is the piece I used. All I did was use a longer bolt. Works perfect. http://www.homedepot.com/h_d1/N-5yc1v/R-202499838/h_d2/ProductDisplay?langId=-1&storeId=10051&catalogId=10053

Not yet got the AX today going to mount that then take her out next weekend. I'll let you guys know.

Thanks guys for $5.00 It works perfect. It had two holes I only used one. You could easily drill one or weld a plate with one.

Have had my roof rack for 6 months and had been wanting to add a AX / Shovel mount. I couldn't see forking over the $60-$75 warrior wanted. Went to home depot got some 3" x 3/8" bolts, fence hardware, washers and fly nut. Total cost was less than $5.00. Might work for a jack as well. Plan on...

That happens on most cars. My Sabb used to have one side lock up in cold weather. I researched and found out your not supposed to set the e brake in certain conditions (any car). Especially if you just stop from driving a lot water will get on the lines and freeze them. Since its mechanical like...

Draper9@me.com

I have a full color 6' printer and can do full color logos that are to hard to cut for vinyl. Don't wanna take any work away from dspan but any thing that's to hard let me know. I'm a graphic artist for living and have most logos in eps too. Would be happy to share them so you can cut the real...

Guessing not lights right?