Recent content by dodgydex

Hello IH8MUDers! I have been searching up and down and over the past few weeks I have been unable to find any info regarding the physical dimensions of the Weber 38 Carb. I hope someone has one handy and can tell me how tall this carb stands without adapter or air cleaner, just the carb itself...

well as far as the NAPA NGK's, NAPA is trying to find if NGK can get a 6V plug, putting out a nation wide bulletin that the listing is wrong and have been very kind and helpful so far. I think they will even refund or replace the plugs I have already installed. I have tried to run a manual...

Sorry I re-read the other posts, via a wilson switch and up to 25 seconds of heating these plugs i have should work. a set of 6V plugs from toyota here in fort mac will run you $320 for a set. So it looks like I need to cut a few wires and put a switch in. How can I know if Im glowing the...

The glow plugs are definitely the 10.5V NGK units. Can't get her started this morning. Looking for some proper glow plugs around town, not having much luck at the moment, ill drive down to toyota and see if and what they are asking for a set. Is it possible to provide the proper amount of...

I re tried the ether and got her to run, I was definitely spraying too much. The glow plugs still may be suspect. The EDIC was the first thing I had troubles with when I i first picked the truck up. It hadn't been run in a few years and after driving it for a half hour the edic started to...

i re-posted this in the diesel section, ill remove this if i can

Hello, I purchased an 84 BJ60 3B diesel in vancouver recently, ran nicely on my drive back to Fort McMurray however I cannot get her started. Installed a new set of glow plugs, oil pan heater, changed the fuel filter and bled the filter, rail, and each injector. installed 2 1200 cold crank...

Hello, I purchased an 84 BJ60 3B diesel in vancouver recently, ran nicely on my drive back to Fort McMurray however I cannot get her started. Installed a new set of glow plugs, oil pan heater, changed the fuel filter and bled the filter, rail, and each injector. installed 2 1200 cold crank...