Recent content by DHwreckage

when are these going to be available....really not digging my steering column mount, currently have a boost gauge, afr gauge and a scangauge on it...its a bit too much!

I hate to say it but I think I like it better with all the cladding.....I regret tossing mine after the wheel wells were ripped off......:bang:

there are already a few threads about this for turbos and superchargers...they usually run an O2 sensor manipulator and 5th injector with controller or an additional rising rate fuel pressure regulator.

just curious, will a 37" spare stick way out on it since its set up for a 35" tire?

We're having too much fun to remember to video it...I'll see if I can remember when the roads are clear!

Unfortunately you are a bit far from me, otherwise id take em...dont really want to deal with shipping seats from Idaho to Colorado!

I am looking to replace the leather electric seats in my 80 series with cloth manual ones, please let me know if you have a set for sale in Coloado!

Just to add to this, my exhaust is pretty solid with no support by the downpipe. I got a 90ish welded in front of the first cat and it is connected with the supplied vband to the downpipe. my muffler guy did add a support down by the muffler on the driver side in case the bellow/flex joint...

Hi all like the title says i wanted to see if anyone has had both cats replaced in a carb legal state. I just installed a turbo and found out that my clogged cats are causing me to produce zero boost under load, which has been tested by disconnecting the exhaust in front of said cats. A well...

if you're worried about them hanging lower you can always go with these: 80 Series DIY Front Axle Relocation Kit FJ80 FZJ80 Land Cruiser - https://redlinelandcruisers.com/shop/80series/3f-e-1991-1992-80-series/80-front-axle-relocation-kit/ which just move the axle forward and don't correct for...

I am not affiliated with these guys at all but i have been looking for a similar solution for mounting a fuseblock or an auxbeam under the hood and found this: This is from Bullet Proof Fabricating...ive never heard of them to be honest there is also an Ozzy company, All Good off-road...

****ing brilliant, just picked one up! Just out of curiosity im guessing the shaft spins in the seal versus the seal spinning with the shaft, any squeaking while youre turning?

I believe you mean the Nitto Recon Grappler, as thats the only 37x11.5r17 they make. If anything it would probably require less massaging to get to work, less frame rub and potentially a better profile if your using narrow rims like the tundra 5-spokes. too bad they aren't severe snow rated...

Nugget, looking at your timbrens from post #940: have you seen any issues with running them without the "cup" for lack of a better word, that goes between the steel mount and the rubber bump?

I just use the seat belt to hold my daughters car seat, most car seats have 3 ways to connect: 3-point or 2-point seats belts and the hooks....,but our cars definitely don't have the special car seat hooks!