Devil's Slide Doug's latest activity

Delta kit, not looking forward to burning in that back plate.

Getting Down to the wire with the 80! Finally looked hard enough to find the source of the creaking/ticking when turning hard. Drilling and welding and plating the frame cracks on the back side of the steering box. Installing a 105 shaft while...

The 40 is as ready as it’s going get. Checking shock length and rear locker!

I’m leading the Thursday morning breakfast run but my 80 is on blocks in the driveway as rebuild a steering box with a 105 shaft. Also drilling and welding the minor cracking on the inside of the frame and adding the delta plating where the box...

#464 2nd hand from Firemedic831. 4 to 1 built by Georg. I’ve already put hundreds of road/freeway miles on it with no issues. Looking forward to the Rubithon next month.

Old thread but here is my solution. Just chuck a brass 1/8 MIP hose barb into a 10x 1.25 die and it is good enough.

I took the time to paint (and clean and lube) the used hubs when I did my front disk conversion on my 40.

Just got back from a test drive after installing a lunchbox locker in the back of the 40.

Awesome, looks like your well setup. Acquiring parts but not sure if I’ll have my steering box rebuilt with a 105 sector shaft. At the very least I’ll have a spare stock box.