davegonz's latest activity

Got the bumper lights installed (pain in the ass due to the bumper being installed) and managed to also install a trailer light harness while I was added. I used that t-connector 1997 Camry harness that others have used. It did require me to swap...

Congrats to both of them. Graduating with an ME degree is hard work, dammit.

Bump it to the weekend after. Some folks might be out of town that weekend.

Doors

passenger side door. Weighs in at 45lbs😳 had to cut out about 3/4” on the cutting board to make it past the down latch. I could have just removed the down latch each time we were going to use the table but that’s annoying.

Nice weekend at Moose Pass. Had some rain really early in the morning.

I also did something with the boys that I have only spoken to them about in passing. I went to Notre Dame and took a pic at the spot that I was dropped off by a bus 31 years ago with some used clothes in a suitcase and $200 in my pocket and had...

@SipLife and his team won 1st place at formula one US national competition in Michigan yesterday!!!! Big accomplishment given they built it from scratch, tested, tweaked, raced, and won in less than a year! They beat out over 70 universities...

Same guy I saw.

FM1626 & Old San Antonio Rd. S. Austin

Driving my 100 with these wheels on it

She made it to the Howler Brother's IG feed!

If you have a RHD truck, these are unbeatable…. https://cruiserconsoles.net/

Look to the FJ60 Tuffy for a best out of box aftermarket fit. Cheers

Can it fit in a flat rate box? Don't need the heater controller. I have your Sprinter sticker and an envelope ready to go. Just need to drop it off. My free time sucks nowadays.

I think I have a stock console out of a BJ70 with the rear heat, if you’re interested.

AC idle up for increasing RPMs when ac running.

Thanks Jed!

Here ya go.

Post a pic. A stock console is what I'll look for.

On mine that floor area is pretty much dead flat so any console with a flat bottom of adequate width would work. The problem is lots of consoles have a rear "step" on the bottom that would mess that up. I also converted mine to stock Toyota...

Yeah, I'll look for a standard 70 console. The Tuffy might need some trimming to clear the parking brake.

Sharsch?

That's the place I was referring to. They TIG welded an AC line on Betty White for me.

Austin Rebuilders on oltorf made the hose for my 60. They do repairs too