Recent content by daflentge

Available? Located where? Thx...

I don't have a leak at this time... but who knows how long they will last. I had to superglue them in place so that when I installed the manifold, they would stay in place. I'll do it again, the next gasket replacement. Good luck on your project. Doug

Thanks guys... I have a relay set up already, no real power through the switch. As for lights, was going to buy an IPF kit from Costco, but wouldn't you know it - Sold Out before I could. It was relay, two lights, mounts, wire harness and 100w & 130 bulbs (4) bulbs total all for just $179...

Question - I have an extra FJ60 rear defog switch, can I use it to switch Aux Lights? Just curious if there is something special about the switch that would prevent me form using it as a simple lighted rocker switch to turn on/off a set of driving lights. The Aux Lights are set up to use...

Desmog Complete & Purring Like a Kitten - Part 3 Schematic I used - along with the FSM of course... Layout with all the bits no longer needed... The FSM... With these tools, the people on this forum and patience... anyone can do this. Cheers - Doug

Desmog Complete & Purring Like a Kitten - Part 2 More Pics... Don't know if I can attach the FSM, it might be to big.

Desmog Complete & Purring Like a Kitten I promised a final tally and here it is... Complete FJ60 Desmog - HAC delete. - Air Rail removed - Plugs from Jim C. - Smog Pump Removed - Idler from SOR - EGR, EGR Cooler, all EGR tubes removed & Intake EGR Tube Mod - Exhaust EGR port capped with...

News to me... That gasket is Toy part# from Toy Dealer with Toy price... ~$32. Guess Toyota knows a good gasket when it comes along.

Exhaust Manifold - Flat & Installed Rover - Thx for the tip... Spitfire did a nice job on the manifolds. I ended up using one Toyota Gasket, and a couple of half washers as shims for the different height of the bolt faces between the intake and exhaust manifolds... Then I replaced the studs...

Desmog Complete & Purring Like a Kitten Vacuum leak was it! My hose on the dissy side from the tee above the PCV to the VCV was shredded, so I just capped the tee for now. Once I stopped the leak she purrs like a kitten.:) Timing is set @ 7BTC, starts pretty well, idles nicely at 600 -...

No Idle Jim C. - Thanks for the suggestions... I'll check for the click first, then put the air cleaner back on with the complete vacuum routing and try again. If I don't hear a click, what should I do as a work around. I'm close... I know I'm close, just a few more tweaks and I think I've...

Desmog Complete - Won't Idle -- Please Help! I've been busy these last few weeks, Manifolds are flat, crack in Intake welded, Carb & Dissy back from Jim C. and I spent the day routing vacuum lines. Per the Desmog schematic. Thanks again Jim C. When I stabbed the dissy in the first time it was...

Rover - Thx for the tip... I'm calling them today. Denver is not that far away.

Sorry antichrist - I just looked again at my exh manifold and now I understand what you mean. If I don't trim it, then it wll hit the SOR flat plate. Thx - I'm a little slow in the morning.:o

Torque Sequence MWEB - thanks for the torque diagram. That is exactly what I was not able to find in my previous searching on the site. :cheers: