cruiserdan's latest activity

Too narrow for me.

FYI The same style wheel is available with back spacing that does not require spacers, but they are narrower than the 80 wheels. I run the narrower wheels on my 70. As an illustration, I snapped the following picture a few days ago while we...

Also needs spacers. Stock backspace on 4x, 55, 6x, 7x is 3.5 inches. I run Spidertrax 1.5 inch spacers on the 74. I have not found quality 1 or 1 1/4 inch spacers.

80 Series standard steel wheel. 42601-60362. Any Toyota dealer can get them. 16x8 with 4.5 inches of backspace. On a 7x you need to run spacers.

I want those wheels. :hmm:

Thank you! I've had it for almost 12 years. It was a bit rough around the edges when I got it but it was rust-free. Here is the thread where all that got taken care of. https://forum.ih8mud.com/threads/bj74-trip-to-the-spa.793856/ Since then it...

Great looking rig Dan !!

She looks like a sweetheart.

Headed to Cruiser Outfitters tomorrow morning for a fresh clutch and a reseal between the transmission and transfer. I've had a gear oil migration from the transmission to the transfer for a long time and I'm tired of monitoring it to keep from...

Stainless scuff plates

Never been to TJ? Great. Fresh tcase leak after driving 600 miles.

Sending PM now! Thanks team.

@Zeus0623 I have two radiator choices for you in North Denver, both are good to go. PM me.

Thank you! Already pulling her out and will see what I can manage. Have a few local shops that I think can do the job. Thanks!

@CruiserTrash may have knowledge of a reputable shop near you Chris.

Factory radiators are discontinued. City Racer offers a replacement. I think they are around 600 bucks. If there Is a "real" radiator shop in your area they may be able to repair it or re-core it. I recently had the radiator in my BJ74...

I have always done points and condenser at the same time. One without the other is like taking a shower and then putting your dirty shorts back on. :lol:

I don't have enough knowledge to suggest a specific component. I would suspect that anything in the current path could be suspect. Points, condenser, grounds, maybe the tach? Do you have an alternate tach you could substitute?

Point gap, .018 inch. Dwell angle, 39-43 degrees. I think of point gap as a starting point. Measured dwell is more precise.

Working on my adventure rig and got some @cruiserdan inspired driving sleeves.

Points, 19145-26060. Condenser, 19133-60040.

What's the part number on the tag on the housing? Starts with 19100-

Not from a vehicle that had the oil changed often. :doh:

Got a new grill and emblem to put on.

I plan to come in from Lake City over one of the more mellow passes. My trailer is untested and my family will be easing in.