Recent content by coues32

Does anybody have a measurement for the Ironman FCP front coilovers settings? Bottom center of bolt to bottom of locking ring ? Looking to 2.5" lift. Just pulled them off and going to have to go get them compressed to reset any help would be appreciated.. Thanks

Thanks guys! Any tips for easy lowering? Jack under lca help?

No problem, working on the back now.

Thanks, looks like better angle on CVS, could you measure center bottom bolt to lower collar bottom if not too much trouble.

Just confirmed 9" setting from Chris at MT, that is where I'm at now???

24 3/4"

They were the unassembled front kit

Do you remember your settings?

2" 2.5"

Set them at 9 " center of strut hole to flat perch as from metal tech. Too high?

Has a little tight spot when spin the tire at full droop, that normal with steep angle? Thanks

Didn't yank on axles,just didn't want to mess something up

9" per mt specs

Installing Iron man fcp lift answer jba ucas. Axle pretty steep angle right now is that normal? I've had axle slip out of socket on a Polaris ranger b4...

WTB fj or 4runner rear coil spring isolators, any place in the valley to check? Junkyards? Thanks Daniel