Recent content by costahh

Pmd

2f is preferable but whichever you have just need them to match

Do you happen to have a bell housing, inspection cover and transmission crossmember?

Are you having any delay issues ? Guessing with the de minimis exemption being eliminated this Friday and with all of the crazy that is happening with international shipping coming to a halt into the U.S. we are going to see some delays? Don't mind paying a higher price due to these...

Installed some BenCC fog light inserts with Diode dynamics sports, highly recommend. Ordered these a year ago and the wrong ones were sent out. He sent out the correct ones asap. Wish I needed more stuff from him cause I would 100% buy from him over and over.

I understand that but it’s nice to know a rough ball park, I know some tend to range from X to Y depending on the shop but I understand it all comes down to the vehicle and it’s specific needs and what the customer wants.

If you don’t mind me asking how much was the drive train swap? I am near and looking for different shops to do a H55F swap if possible at least in Arkansas it seems like we don’t have as many options as either coasts do.

Sent you a PM

Pretty simple, I ended up cutting off the factory plug and wiring in a Deutsch connector to mate to the aftermarket lights, in my case Diode Dynamics. Works with the stalk factory fog light switch took all of 15 minutes. I ordered the crimper and Deutsch kit off amazon I can link in what I used...

I have one it is in ok condition ? I will try to snap some pictures of it later today

What years are they from? I am looking for a transmission crossmember and drive shafts if they are from a later year

For sure will! I did see that Cruiser Matt sells a pedal kit now a few oddities that might make it more expensive but a bit easier.. might be a route I end up taking.

Have been following along for a while and am about to start collecting parts for my H55F swap. My transmission is showing signs of hard shifts and am going to try to adjust the throttle body cable / replace to see if it cures the woes for now, knowing that will probably be temporary. Definity...

Shouldn't be too difficult with the bend, I bet if you find someone who has the awning mounts they could follow that bend or use that as a nice start for an adapter plate

Would possibly be interested as well, I always wondered why Dissent did not offer this in their lineup. I am curious though with the vendor you are going with, will there be enough space between the back window and side panel to where the side window is still operational or will that be...