Recent content by charginj

I haven't seen any mention or noticed anything such as that. any idea were it may be located as its worth a look. Cheers

haha simple sounds good but not always simple. Blower speeds seem fine and all work. Pressure switch looks like its on the high pressue side. you have compressor into the condenser and the switch is just after. Switch is pluged in, I have removed plug and and put a jumper wire across and that...

Hey Nissanh I am assuming that your referring to the climate control set temperature. My model is the basic model here in Australia and it doesn't have climate control, just an on and off button and you just adjust it with fan speed.

According to the electrical diagram its a dual pressure switch. Cheers

Gday Was hoping someone might be able to guide me in the right direction. I have Hzj105 cruiser which the ac has never worked since I purchased it and I have decided to sort it out. The previous owner had found a leak in the evaporator and had removed it as well as the expansion valle prior to...

Running toyota 60 series front axle and 80 series rear. Haven't decided if were running the h55f transfer or the h150f from the 80 series. Have been told that the 150f is stronger but don't know if you can get a crawl box to suit. Have been looking at the klune 4 -1 from high impact but haven't...

I am building a 60 Series comp rig for rock crawling and need some help with ideas on what driveline configuration to run. We have chosen to run a 5 litre v8 and th400 automatic gearbox which we have from a previous unfinished project and require a under drive or crawl box which can be mated up...

Hi all i have installed a pto onto transfer case but it doesn't seem to engage properly. I haven't installed the shifter yet but if you pull on the linkage to engage the pto it seems to mesh but if you rock the pto out put shaft back and forth it pops out. I have installed the pto using a gasket...