Recent content by captcory

driveshaft found I found one thanks for the replies

I need a driveshaft that will fit the 78 and up fj40 flange ( 68.5mm X 60mm) pattern. any condition I need it to cut up and use for a custom front driveshaft. shipping to Florida 34224.

sputnik40, what is that radius arm out of? That looks like a quick and easy traction/anti wrap bar set-up. No need to fab a bar..already done for you. just attach to axle and make up a shackle and your done. I like it.

pull the wipers and the steering arm and this is what you end up with...very easy. remember to spin the disk or the birf will not come out.

I am having the same problem. very little clearance after a cut and turn. I talked to luke and he can re-bend the arms to clear.

pm sent

1989 4 runner about 160,000. the engine is apart from a blown head gasket. real straight and a couple of dime sized spots of rust on the removable top (surface rust only, no holes) faded gray paint. auto with 3.0 engine. clean florida title. Located in Englewood FL. 1.5 hrs south of Tampa. It's...

I too am interested. another source for a pump although expensive is a pump from a mercury marine verado outboard. I've used one in a boat and they are sweet.

got your e-mail. I'm still in. cory

I've been trying to get a hold of you regarding these arms. I finally got my axles. Pm me. I have rover stuff to trade.

try this link a little cheaper MB-2 Caliper

damn locals

that would be me...pm sent

will you ship to florida? 33901

wanted 68-84 40 axles. need to be located in Florida. prefer disk brake but tell me what you got. $0-$500 e-mail "cory at ewol dot com"