brian's latest activity

i should have known, mcmaster has everything. thanks

Just clip to pin in door hinge so it’s removable if concerned.

I have no soft doors for it, and obviously hard doors will not fit, but I would have to assume that yes, they would interfere with hard doors.

$or seat covers f&r, at first I was rather heated but have since cooled and accepted it.

Safety first, make it last.

Just on the PS.

is there one on both sides or just the ps?

Turned out great

Yup, that looks like crap. But you knew it was a big piece of non-OEM crappy blue plastic when you ordered it. Or is it just the plug wires you don't like?

Chinesium distributor?

weld and drill

I just put some white lithium in them. I want them to work, but honestly they're not going to see much rain any more.

Horns are next

Turns out 2f valve cover grommets work for wiper motor packing too. I dont recall what if anything was used for the interior fasteners for either a packing or a spacer, as i don't think the gap was quite as large with the oe rubber gasket.

Mount the drinks holder on the backside...works surprisingly well.

Daystar, is better quality. The energy suspension, the plates are two pcs and use sae hardware instead of metric.

International Harvester Red The Farm and Implement is the best spray paint I’ve found.

Irrc the only only thing that's actually toyota or land cruiser about them is frame, or bits of it and the vin tag.

What was wrong with the springs that were in place?

it has zinc in it, but i wouldnt say it has alot of zinc in it.....that was reduced 10 or 15 years ago.

I’ve been keeping track of the progress you’ve made, but somehow missed that you were rattle-canning it all along. This “reveal” shocked me…so good!

what color?

what vender sold you those springs?!?

Pop the cover