Recent content by BrettFriebel

My Apologies, 1994 Land Cruiser

LOOKING FOR A PAIR OF FRONT MUDFLAPS.

Could you pm me or post some pictures of where, and how you mounted your sliders?

Makes sense, I'm trying to find a salvage yard that has a front diff set up that I can swap out. Otherwise, would regearing to 4.88 replace most of the parts in the front and rear that could be causing the howling? Also with the front driveshaft out and the CDL locked, are the gears and axles in...

My 80 doesn't have factory lockers.

Is the VC as easy to put back in as it is take out?

Maybe I'll just take the VC out and see if the howling goes away

It has a stock suspension for now, and the only reason I'm thinking VC is because the howl is gone when I lock the center diff even with both drive shafts installed. But I'll have to get under it and check out all the things you listed.

Noise was present before all that work.

Knuckle grease is good, front driveshaft u joints are good because I just replaced both of them, replaced both front wheel bearings. I also changed the front and rear diff fluids and the transfer case fluid. There is also no signs of any leakage from the knuckles, pinion seal, or transfer case.

While I'm turning the wheel, should the driveshaft rotate as well?

I haven't tried that, I only unlock the center diff once I out the front driveshaft back in and that's when I'm getting the howling.

Tires are all the same size, I have the CDL locked in HI with the front driveshaft out right now and the noise is still absent. Howling is only present with CDL unlocked. Does it matter if I lift a front or rear tire to try and turn it?

I've been having a howling noise under load at around 40 mph, I locked the CDL in HI with both the front and rear drive shaft still on and the howling was gone. Could this be the VC, I have a 94 Land Cruiser

Looking for some rear bumper end caps for my 94 Land Cruiser.