Recent content by boisescott

thanks for the info. I pulled it off (it took a little more force to get off than I expected). what is the best way to get the locknuts off/out?

Hello all. I am replacing the bearings on my left front wheel and am stuck. I got the cone washers off but when I went to pull the free wheel hub cover off of the studs it slides out but stops short of coming all the way off. It looks like the inner hub is interfering and preventing the outer...

I picked up a used one to at least get me through a little while. I tried to get the aftermarket but the places I tried had it backordered. I've had good luck with the used parts from cruiserparts.net so I'll give it a shot. It also cost about $217 less than the aftermarket part and about...

Thanks for the info Brad. It is greatly appreciated. Scott

Thanks for the reply Mike. Do you remember the size of the socket? The main problem is that the vehicle isn't near a town/city with any type of socket store thus I am trying to return prepared with the correct socket size. I should have measured at the time but spaced it.

Does anyone know the size of the nut on the crankshaft? My pulley broke and I have to replace it. The problem is that it is about 5 hours away so I can't measure it lol. Thanks in advance.