Recent content by Birfield

  1. B

    Caliper Rub After Knuckle Rebuild and New Rotors

    Unfortunately I threw the original rotors away before I got a chance to measure them, but both sides are rubbing the same. At this point I'm probably just going to live with it and pick up OEM rotors next time and see if I still have the same problem. The calendar is what sealed the deal for me ;).
  2. B

    Caliper Rub After Knuckle Rebuild and New Rotors

    Just went and measured the washers. They were 2mm and seemed to center the rotor perfectly.
  3. B

    Caliper Rub After Knuckle Rebuild and New Rotors

    So this past summer I rebuilt my knuckles and at the same time put new pads and rotors on. When I went to install the calipers the rotors were rubbing on the outer part of the caliper on both the drivers and passengers side. At the time I just put some XXmm washers in to get by, but I'd like to...
  4. Rotor Measurement

    Rotor Measurement

Back
Top Bottom