Recent content by biltnotbought

Easy test and easy fix if this is it Turn key to on Run hot wire 10 ga or bigger from batt towards solenoid terminal and just touch terminal to turn motor over and hopefully it starts If it starts Time has corroded all contacts and you getting like 10 v To solenoid If it starts then just...

What vehicle is it in ?

Looking for ideas on converting Toyota coaster to 4wd then to camper . 2-3 companies in aus perform these conversions regularly My narrow brain Thinks this Rear axle switch to SAS Then super singles Atlas or np205 divorced t-case, cable operated Convert front end to leaf spring Add...

Thanks for getting back so soon . That's what I was hoping. I assumed not all 1hdt motors were equipped with a/c Thanks again Tommy

Sorry this is for 1hdt engine

Is the ac pulley an additional vibration damper. Im not gonna run an ac system,and I could use the additional space for my cooling system fan by completely removing the lower pulley. Thoughts Thanks in advance for any help ... T

Sorry, I know this is really old. Do you still have rear 45 roof to tub latches. Thanks Tommy

I d be interested in tailgate bed floor and roof rack send PM with quotes. Shipping zip 87122

Tach done ! Took black wire with silver dots from old igniter harness( tested it to verify it was the pulse wire at the cluster) to black wire out of pump.. Brown wire from pump to ground .works great look great. stock fit!

Thanks !!!! Will do that today .and is the wire going into the pump just a switched 12v power source ?

Searched threads no luck .need help hooking up fjz81 tach from rocky mountain parts into fj80 w/ 1hdt. I'm guessing brown wire on(IP) fuel pump is 12v in and black is pulse out?? Tach has 5 terminals pos, neg, p, swb-b and CHG.? I'm guessing black pulse wire from pump to p wire on tach...

newbie here,with some basic performance improving questions? short of replacing turbo /bigger injectors. are the basic power tips a turning up fuel screw and adjusting waste gate for higher boost levels and bigger exhaust . has any one ground the fuel pin or shimmed it for to sit lower in the...