Recent content by Bhudzallmighty

315 / 70 / 17. thank you

Thank you. Did you trim the the bumper as well?

Hi. It's all good, I've trimmed the cladding already. Thank you!

I sent him a messaged so hopefully there is a way without dhaving the body trim

Has anybody installed this on their lx450? The body trim seems to get in the way.

Do you have the part no for the solenoid?

So I filled up gas the other and I parked backwards on the driveway (front down, rear up) and gas started pouring out by the front side of the tank. I’ve had the hissing sound symptom from My gas tank but they were not terrible. I already ordered a vc120 charcoal cannister. I will be changing...

6 other ones still have the welded nuts so I will keep them. Will only repair the 2 other ones How about the other roof rack support in the middle? Do I need to seal those as well?

Thank you for the suggestion guys! Just bought a rivet nut tool

Im getting ready to install my prinsu rack and of course it won’t be an 80 experience if everything went smoothly 🤣. 2 out of 8 welded nut came off. I plan on using SS bolt with rubber gasket + toyota fipg to seal the holes but not sure what will be the best with the other 2 holes without...

Just about done cleaning my birf housing and other misc parts. I used LA’s awesome degreaser and engine degreaser to aid removal of built up gunk. Do I need to clean with a different solvent to make sure the new grease will not get contaminated? Or if is it fine as long as its dry? I just wiped...

Thank you so much!

What grease would you recommend? Yeah that was my plan if I were to replace the tie rod ends.

Slowly working on rebuilding my axles. Tie rod end gave me a lot of trouble but I was successful. I used a tool that slides under the tie rod end and you screw the other end to put leverage. It took a lot of force to get it out and it looked like my tie rod end took a hit? The bottom boot does...

I recently revamped my A/C system with new condenser and drier. Cleaned the evaporator and used the same compressor (had no issue before or leaking). I added oil on the new parts per one of the write ups here. No grinding i noticed initially on my first two tests but after I had it sitting...