Recent content by Balgar

Hi All, So my current problem with my 60 Landcruiser 2h Diesel is the EDIC control rod is not moving when i turn the key to on. Then when i crank the engine over, the control rod is still set to off. When i manually move the rod to on and turn the key the engine starts. I bought a second hand...

Hi all, I need to get a replacement glow plug relay with the code 28610-54090. I have found one on eBay for 150 but the issue is the the number below the id is different to the current on one my 4x4. The new part has a sub part number of 056700-5811 while the original is 056700-5810. Last...

So is there any recommend kits or can a cheap eBay work. There one for $40 in Australia for two breather point. If I have to replace the fitting on the diff what size do I need? Or can I use the ones in there? As per suggestion above might be easier just to by zip ties and 8mm plasitc tube.

Could I just lock one front wheel so the gears move when driving?

What if I get a turbo kit? Will make engine hitter and perform better.

Need to get a diff breather for my 60 series landcruiser. Found water got into the front diff front po. Fist question is do I need to replace the front diff? I would like to go 4x4 but mainly use the 4x4 for sand. I replace the diff oil and still works. Second is do I just get breathers for the...

I got a 2h engine rebuilt by PO. When running the oil pressure is high around 75 to 80 % mark. I asked a mate and he said it might be high flow oil pump. Would this be right? I also got a 5 core radiator and drive around the city, the temp gauge goes just above c. When driving for about 2,5...

i am unsure what the temp compensated adjustable does but i am assuming that it regulates the voltage. see attached picture

Thanks, checked that but i had different unit called "Temp Compensated Adjustable" that has a blown fuse. when i replace it, the alternator worked but this was the original one. I am currently putting in a 80Amp alternator for OEM and for some reason it does not charge. the original one does...

left power wire off battery when changing alternator and truck started first time but no volts coming from alternator, 11-12 volts. then tried to start again to test and the truck didn't want to start. had a look and put the wire back on and the truck starts but now but no voltage still. power...

Thanks, i will run the 10.5 for a few a month until i get paid again, then buy 6v and put those in. thanks everyone for your help.

got the volt meter and checked the gold plug rail. when starting it read 8.2v then dropped to 4.2 v. does this mean 8.5v glow plugs are needed?

i guess the best way is to get a volt meter on the glow plug when starting and see what volt it is at to determine the right glow plug. i just worried that i have the right glow plug in there now, as my volt gauge on the dash starts at 8 and when i turn the car on, it goes to 10. also the...

i had another look at where the voltage is at when i first turn on the key, and not realising that the meter start at 8 and not 0 so when the glow plug is warming up, it is at around 10. when i changed the glow plug from 6v to 10.5v, it started up the same before and after which was why i...

sorry meant to say if anyone know which Glow plug relay is needed for the 10.5v system