Recent content by Ayetee

I like the look without them better.

No spacers, the center caps need to be cut to fit but i dont care That much.

Ome 851 862, sterring damper caster not needed bit in truck...

193k miles, engine stuff next oil, air, red coolant,

Hey guys, just got out of the shop first lift ever, cb in ashtray uniden pro if pro part matters i forget, dual din, wood grain off, fj c fresh take offs! 5 questions? This is my build, suggestions? Thanks!

oh ok, maybe i need to up my seroquel?

I tried simple green on my tires, and even let it sit, all that! my question is what if i used a electric pressure washer would it blast off rubber still, like a gas one might (as i immagined)? or be just enough power to blast off grease? if youve got an old tire & an electric pressure washer...

What about 33x13.50x15? I got these already because my dad hates them on his 40. I just have to pick them up at mechanics today, thanks.

summer haze so... ive been taking my vitamin D, and its winter. it now is the best time to remove this crap if its warped. but id like to add on some tips... use a big, big flat head and smooth out the edges so its not sharp. because anything else will cost..and im sure you have a screwdriver...

Oh, FYI...because I'm thinking of buying a roll. I'll sell the ret most likely after.

I have seen a thread on this. Does anybody know what the % is of the rear I'm pretty sure it's all the same %. But I want the exact same % as rears in front because even if it was bronze lumar or whatever the different % shade would look sh1tty in my opinion and if you know what I I'm talking...