Recent content by Angusbull

Has anyone done or know someone who has done a ford 302 swap into an fj60 using the stock 4speed manual?

I have a 1990 Landcruiser with the following rebuilt or new items; Front outer lockers, knuckles, front and rear diffs, front and rear drive shafts, Transfer case, tie rod end kit, steering stabilizer, rear wheel cylinders, axle seals and bearings, distributor cap, plugs, plug wires, battery...

I have a fj62 that all of the drivetrain except the motor has been rebuilt. The engine has 192,000 miles on it but doesn't smoke, leak or use oil. If your just looking to add the toys to it this one would be a great starting point. It's listed on these forums as 1990 fj62 (angusbull). By the...

PM me and I'll send picks. The cruiser is a southern vehicle, Alabama. It is located in tampa Florida now.

I have a 1990 Landcruiser with the following rebuilt or new items; Front outer lockers, knuckles, front and rear diffs, front and rear drive shafts, tie rod end kit, steering stabilizer, rear wheel cylinders, axle seals and bearings, distributor cap, plugs, plug wires, battery, power antenna...

Front and rear bumpers shipped to 33603

Need front and rear bumpers. 33603

Do you have the front and rear bumpers? If so how much shipped to 33603?

Bumpers Need front and rear bumpers.

It turns out that after the knuckle rebuild the locking hubs were reassembled incorrectly and the front drive shaft was engaged the entire time. reassembled correctly and walla.:clap::beer::beer::beer::beer::beer::beer:

I've put new diffs, drive shafts, u-joints, rebuilt knuckles, shifter boot is intact. The noise I'm getting is like a growl, It doesn't sound normal.

I'm running 31, 10.5. I have 4:11 diffs. and at 60+ mph and 2300 rpm, I get a roaring noise from my transfer case, that was rebuilt before I bought the cruiser, also the cruiser starts shaking. I do have new tires and wheels, although the guy at the shop said he feels some bounce at low speeds...

I took it off and blew air through it, it seemed to be functioning properly. I'm wondering if it was just a loose connection? It has not leaked since.

Found another issue. There is a black plastic part inside the rear quarter panel where the filler neck is, it has five hoses running into it. There's a small one which is the first one closest to the filler neck and up high on the part, then there are 4 more on the lower part on this plastic...

With the water pump, was there constant vibration, or at certain speeds?