Recent content by 84shortyota

Two brand new Toyota OEM bushings. For front panhard bar. 48706-60030. $40 shipped. Located in Hillsborough, NC.

I have two D49422A shift solenoids. I bought these for my FZJ80 and never installed them. Brand New in box. Made in Japan. $40 each shipped or both for $70. Located in Hillsborough, NC

It's close to done for now, first trip will be next weekend. 1966 Johnson Furnace M416. POR15 on the frame and bedliner everywhere else.

Just finished it today, kinda. First task...

I'm still dealing with the power "surge". It comes in around 2600ish RPM's. I've just learned to put up with it. Kinda sucks. I have 4.88's and it still feels like it did with 4.10's until the surge happens...

Do you happen to remember the part # for the shocks?

I'm looking for an AC compressor bracket and a power steering reservoir for an FZJ. Anyone got any spares laying around?

You could build another small swingout on the right side and mount the jack and a jerry can holder on it.

Thanks for the bumper pics by the way!

You have to be careful with the chevy wheels. Some of them have smaller hub openings and wont fit over Toyota hubs. I believe 80's need a 106.1mm hub opening in the wheel. You'll also want to make sure the backspacing is the same or close enough not to make a difference. You'd almost be better...

Haha no. I did run it in a Gambler 500 though. It did great! Lifted and locked on mud tires. It was a tank!

Yes i have

I'm running Spartans front and rear and love them. I get a pop every now and then from the rear when its bound up in a parking lot or something, but they always work as they should and are cheap and easy to install at home. I've been using them in various vehicles over the years, including Volvo...

Are you running spacers?

Any other pics of that bumper? I'm a fan of simple designs!