Recent content by 6T9cruzr

Thanks for all the info. To clarify based on the info you folks have provided, I am looking at putting an early 2F in to replace the original F. Before throwing a rod on F engine, I installed power steering a few years ago. I also installed an electronic ignition distributor in the old F...

Great info. Much appreciated. anything you know of that will not transfer?

I have thrown a rod in my old F engine. If I go to an F2, will I be able to use existing attachments, such as distributor, carb, exhaust manifold, fuel pump, etc? Any pitfalls? As long as I am jumping should I consider a newer Toyota engine such as an F3 and will it fit? I have a 3 a speed...

Thanks so much. Can you share with me anything you know about fuel boost? Several years ago I put in solid state ignition. Will that be a factor? Much appreciated. I won't be doing the work myself- have an old school technician that is a wizard. Better to have him do it than me!

Thanks!

Would. Be interested in knowing results- install difficulty for instance. Are you having to install a stronger fuel pump? Fuel economy changes?

anyone have any experience installing EFI on an original F engine (69)? Any suggestions, ideas, recommendations welcomed!

They are Corbeau. Bought them several years ago.

Thanks kindly. I will.

Where did you find the kit?

Josh, I assume you fabricated your seat bracket. Nice job.

Weird question, but where is the gas tank on later models? 69 sits under passenger seat.

Thanks. Not familiar with later model brackets. Am i understanding correctly that the later models have a bracket that can be set over the toolbox? How do you access the box if that is the case?

New to site, and have searched to no avail. Apologies if this has been asked before. I have A 69 fj40. Several years ago I installed Corbeau Buckets using the original bench seat frame. Seats and tuffy console installed, but the seats have always sat too high. The driver seat sets on the...