FJROSS

Ratchet straps worked like a charm. I installed the hook on the interior lip of the fiberglass top and the other on the windshield frame and was ever to crank it right into position. I then had to pooch it forward a bit in the same manner...

I may have to give this a try. I may cut some wood spacers, so I don't jeopardize the rain gutter. Maybe I can attach the door bow to the top and use that to pull the top into place.

I'm finishing up a body off restoration on a 77 40. I had to replace the (2) rear lower corners so the upper flange was never removed from around the bed and the bed was supported when doing so. The two sides of the hard top are installed as well...

Heritage replied back to me, and they have the clips I'm looking for back in stock although he is away at the moment. He just has to revise his website, and I should be good to go. Thanks for your input. Dave

Nate, Unfortunately, all the parts are out of stock. I sent an email this morning asking when they might be back on their site. Haven't hear back from them yet.

Thank you, this is the one that comes on the retaining band from City Racer. it's the (3) pieces that mount to the floor I'm after.

Thank you, I'll give them a shout and see if they plan on producing these again.

Finishing up a restoration on my 77 FJ 40. I posted up in the (Parts Wanted) section but was wondering if anyone would have the set of (3) clips to hold down the tool bag under the driver seat. (2) retain the rubber retaining band and the other...

Hi, Looking for the brackets (set of 3) for attaching the large rubber band under to fasten tool bag under the driver seat on a 77 40. 2 brackets hold the band to the floor and the other accepts the steel bracket on the band for fastening

Do the above clamping of hose to alleviate all the other issues that maybe your problem. I had air trapped in my rear aftermarket cylinders that had to be dissembled in place while bleeding to burp the air. AS per 6F40j9 commented, this led me...

If you take a look on CR website (I believe on his windshield gasket), there is a video using the string method where you install a string in the groove/lip that's on the window gasket. This is the groove that sits in the metal frame of the door...